Taylor Tool carries a wide variety of threading taps and dies. Below you will find a short list of some of the taps and dies we carry and how they are furnished. For sizes and pricing contact us by email (colleen@taylortool.ca) or by phone (519-658-9378).
Threading Taps
Standard
Hand Taps (HSS and CS) are furnished in the following form of threads: National
Coarse, National Fine, National Special, Whitworth Standard, and British Standard
Fine. Hand taps to and including 3/8 inch have shanks full diameter of thread.
Taps 7/16 inch and larger have shanks smaller than the root diameter of the
thread.
Spiral Pointed Machine Screw Taps (HSS) are furnished with American National form of thread in plug style. Cut thread taps will be furnished unless ground thread are specified. Commercial ground thread taps will be furnished unless precision ground thread are specified. Precision ground thread taps are furnished in National Coarse and National Fine only, with pitch diameter limits from basic to basic plus 0.0005 inch. Taper and bottom taps are special. Left-hand taps are special.
Spiral Pointed Hand Taps (HSS and CS) are furnished with American National form of thread in plug style. These taps to and including 3/8 inch have shanks full diameter of thread. Taps 7/16 inch and larger have shanks smaller than the root diameter of the thread.
Pulley Taps (HSS) are furnished with American National form of thread in plug style. Cut thread taps will be furnished unless ground thread are specified. Taper and bottoming taps are special. Left-hand taps are special.
Straight Shank Tapper Taps (HSS) are furnished with American National form of thread and plain round shanks. Cut thread taps will be furnished unless ground thread are specified. Left-hand taps are special.
British Association Taps (CS) are finished with the British Association form of thread in taper, plug or bottoming size. Also supplied in two flutes, spiral point. Please inquire. High speed steel are available in both cut thread and ground thread. Note that high speed ground thread taps in Whitworth form are made to order only.
Contact Taylor Tool by email (colleen@taylortool.ca) or by phone (519-658-9378) to order your threading taps.
Threading Dies
Adustable
Round Split Dies (fractional sizes) are furnished with National or Whitworth
form of thread. National form is shipped unless otherwise specified. HSS Dies
are special. Left-hand dies are special.
Adustable Round Split Dies (machine screw sizes) are furnished with National form of thread. HSS Dies are special. Left-hand dies are special.
Adustable Round Split Dies (pipe sizes) are furnished with American National form of thread. The diameter of the thread at the small end is such that the American National pipe plug guage will screw flush with the face of the die. Straight Pipe Dies are special. Left-hand dies are special.
Hexagon Die Nuts are designed and supplied for running over bruised or rusty threads. They are not intended for cutting. Made to standard Spanner sizes, and from heavy section steel.
Solid Square Bolt Dies have two and one-half to three threads chamfer on front face and one and one-half on rear face. Left-hand dies are special.
Contact Taylor Tool by email (colleen@taylortool.ca) or by phone (519-658-9378) to order your threading dies.
J. A. M. TAYLOR TOOL CO. LIMITED | 4 GOEBEL AVE. CAMBRIDGE, ON N3C 1Z1 | TEL: 519.658.9378 | FAX: 519.658.6799
